User`s manual

NetWare
UNIX
Windows
OS/2
Macintosh
Section 12: Test Button AXIS 5400+ User’s Manual
142
Factory Default
Settings
Follow the instructions below to reset the AXIS 5400+ to the factory
default settings:
1. Remove the external power supply to switch off the AXIS 5400+.
2. Press and hold down the test button, while you plug the external
power supply back in. Continue to hold down the test button,
until the network indicator begins to flash at one second intervals.
This should take approximately 5 seconds.
3. Release the test button and wait until the network indicator
flashes at least five times.
4. Press and hold the test button again until the network indicator
remains constantly lit.
5. Restart the AXIS 5400+ by disconnecting and reconnecting the
external power supply.
The AXIS 5400+ is now reset to factory default settings.
Note:
All parameters except Node Address (NODE_ADDR), Internet Address
(IP_ADDR) and DHCP enabled or disabled (DHCP_ENABLE.) are reset. If you
want to change the these parameters, use either AXIS NetPilot or any standard
Web browser. Please refer to Section 9 Management & Configuration, on page
92.