User`s manual

NetWare
UNIX
Windows
OS/2
Macintosh
Section 11: Upgrading the Software AXIS 5400+ User’s Manual
140
4. Type the command:
put <software name> FLASH
where
<software name> is the name of the new print server
software, e.g.
5400+_620.bin
5. Wait for the Flash loading operation to finish. This normally
takes 1 to 4 minutes. The unit automatically restarts with the new
print server software.
6. Log out using the command:
quit, bye or exit
depending on your FTP version.
Note:
Upgrading using
AXIS NetPilot
This method is recommended for upgrading the flash memory in
NetWare networks. An Upgrade Wizard is available to guide you
through the necessary procedures.
Follow the instructions below to upgrade your print servers:
1. Obtain the firmware file, using one of the methods presented on
page 137.
2. Put the file in the AXIS NetPilot ‘Upgrade’ folder. This folder
resides in the same folder as the AXIS NetPilot program and was
created when AXIS NetPilot was installed on your client.
3. Start the Upgrade Wizard by clicking on the Upgrade icon on the
AXIS NetPilot toolbar.
4. Proceed the installation by following the instructions that are
presented to you in the Upgrade Wizard.
If you need more information, please refer to AXIS NetPilot on-line
help.
Should you encounter any problem that prevents a successful upgrade over your
network, it may become necessary to perform the flash loading operation via the
parallel port, LPT1. In this case, you are advised to contact your dealer.