User`s guide

AXIS 540+/AXIS 560 User’s Guide

1. Connect the Hardware

1. Make sure that the printer is switched off and that the Power Adapter is disconnected from

the print server.

2. Locate the serial number, found on the underside label of the print server, and write it down.

Example: S/N: 00408c181cf0

3.Connect the print server directly to the printer’s printer port or use a printer cable.

4.Connect the AXIS 540+/AXIS 560 to your network (Ethernet Connector), using a twisted pair

RJ45 category 5 cable.

5. Switch on the printer and make sure it is ready for use.

6. Connect the Power Adapter to the print server. The Network Indicator will start flashing when

the print server is correctly connected to the network.

7. Wait 1 minute and press the test button once. A test page will be printed on the connected printer

— keep it handy during the installation. The test page will show the print server’s IP address,

MAC address, firmware number, etc.

Test page

Print server’s

IP address