User`s manual

The Test Button
AXIS 540+ / AXIS 560 User’s Manual 119
Section 14 The Test Button
The test button is located on the front right hand side of the AXIS
540+/AXIS 560 and is used for:
• Printing a test page to check the connection to the printer.
• Printing a parameter list to see the print server’s current settings.
• Performing a Factory Default of the print server.
If you want to change any of the parameters, use one of the methods
described in Management and Configuration, on page 84.
Printing a Test Page Press the test button once to print a test page. The test page contains
basic information about the AXIS 540+/AXIS 560. It is recommended that
you print a test page every time you connect the print server to a printer.
Note:
Printing the
Parameter List
Press the test button twice to print a parameter list showing the current
AXIS 540+/AXIS 560 settings. This list provides comprehensive details of
all the parameters and their current status. Refer to Section 17 The
Parameter List, on page 126.
Performing a Factory
Default
1. Remove the external power supply to switch off the print server.
2. Press and hold down the test button while you reconnect the external power
supply.
3. Continue to hold down the test button until the network indicator remains
constantly lit. This should take about 20 seconds.
4. Restart the print server by disconnecting and reconnecting the external
power supply
.
For AXIS 560: if just one of the ports is connected to a printer, the test page will be printed on
that port. If each port is connected to a printer, the default setting is to send the test page to
1) LPT1, 2) COM1, 3) LPT2. The default behavior can be changed from the print server’s
internal Web pages under Admin | General Settings => Change.