User`s manual

AXIS 282/282A - Installation

ARP and Ping in Windows

Assign your product a unique IP address from a computer on your network as follows:

1. Acquire an unused IP address for the AXIS 282/282A from your

network

administrator.

2. Connect the AXIS 282/282A to the network using a standard network cable.

3. Find the serial number (S/N) located on the memory capsules on top of the AXIS

282/282A.

4. From a computer on your network, open a Command Prompt, i.e. from the Windows

Start menu, select Run... and type cmd (command in Windows 98/ME). Click OK.

5. Enter the commands:

Syntax:

Example

6. Start/restart the AXIS 282/282A. This must be done no later than 2 minutes after

entering the ARP and Ping commands.

7. When ‘Reply from 192.168.0.125: ...’ is displayed (approximately 10-15 seconds), type

Ctrl+C to stop Ping.

8. Start a browser and enter the IP address in the Address/Location field.

9. Press Enter.

10. Enter a password for the root user (administrator).

11. If required, accept the installation of AMC onto your workstation.

Note:

AMC must be installed to view live video images in Microsoft Internet Explorer. If your working environ-

ment restricts additional software components, you can configure your AXIS 282/282A to use a Java applet

for updating the images. See the help file under Live View Config > Layout > Default Viewer for Internet

Explorer for information. Or use another supported Web browser, see Technical Specifications, on page 65.

12. The installation is now complete. Proceed to Using the Video Server, on page 9.

arp -s <IP address> <Serial number>

ping -l 408 -t <IP address>

Note: The ping command is

followed by -l (lower case L)