User`s manual

AXIS 262+ Hard Disk

To replace the hard disk:

1. Disconnect the power cable.

2. Unscrew the cover screws (two on each side and three on the back, see AXIS

262+ rear panel, on page 8) and remove the cover.

3. Disconnect the hard disk’s IDE and power cables.

4. Unscrew the two screws that fix the hard disk bracket to the AXIS 262+.

5. Remove the bracket, loosen the screws that connect the hard disk to the bracket

and remove hard drive.

6. Insert a new hard drive into the bracket and screw the bracket to the base of the

AXIS 262+ again.

7. Attach the power and IDE cables, replace the cover and reconnect the power

cable.

8. Reset the AXIS 262+ to Factory Default settings. See Factory Default Settings

under Resetting the AXIS 262+, on page 32.

Note:

Ensure that the jumper settings on the new hard disk are set to master.

Flash memory

Unscrew the screws that

Disconnect power and

The hard disk bracket

can then be removed

Hard disk drive

IDE cables

fix the bracket to the base