Operating instructions

- 8 -
Installing Axis 231D/232D Camera
(cont.)
7. Then start (3) 8-32x3/8” plillips head screws onto the 3 inch
spacers inside the housing. Be sure to place the screws so that
they line up with the (3) open slots on the quick release bracket,
the screws on the bottom of the camera, see diagram below.
8. Since the 231D/232D camera operates on 24vac, the power
board that is located inside the housing is not needed. The
remove the power board, start by loosening the screws on the
terminal block and disconnect the orange and red wires.
9. With a Phillips head screwdriver remove the (4) machine screws
holding the power board to the base bracket.
10. Locate the connector
block, which is
included with the
camera. Then
located the connector
block bracket, which
is included with the
housing. Attach the
block to the bracket
as shown in the
following diagram.
Use the M3 screws
and washers that are
located in the housing
packet.
11. Attach the connector
block assembly to
the housing using (1)
6-32x3/8” screw and
star washer located in
the housing packet.
(3) 8-32 x 3/8"screws
Machine screws (4)
Base Bracket