Operating instructions

- 4 -
2. In the kit there are (8) aluminum spacers - (4) 1" and (4) ½".
Thread (2) spacers - (1) 1" and (1) ½" - on top of each of the (4)
2" spacers that are already located on the base bracket inside
the housing.
3. Then start (3) 8-32x3/8” phillips head screws onto the 3½ inch
spacers inside the housing. Be sure to place the screws so that
they line up with the (3) open slots on the quick release bracket.
4. The camera assembly in the housing, sliding the (3) open
screw slots over the screws in the housing. Slide the bracket
forward, and the tighten the captive screw on the bracket
½" + 1"
spacers
Captive Screw
(3) screws
in housing
Installing Axis 213 Camera
1. Install the camera onto the quick release bracket using (2)
10-32 x 3/8” screws and star washers provided in the packet.
Attach cameras using these inserts
½"
2"
1"