AXIS 250S Blade Rack Solution Installation Guide
About This Document use the equipment according to the instruction manual This document is intended as an addendum to the video server User’s Manual. It includes instructions for installing the Axis Rack Mounted Video Server Solution on your network. Later versions of this document will be posted to the Axis Web site, as required. Australia - This electronic device meets the requirements of the Radio communications (Electromagnetic Compatibility) Standard 1998 AS/NZS 3548.
AXIS 250S Blade - Rack Solution Installation Guide The Axis Video Server Rack will fit up to 12 rack mounted Axis Video Servers (Blade Servers). This installation guide describes the hardware installation of the Axis Rack Mounted Video Server Solution.
AXIS 250S Blade - Rack Solution Installation Guide AXIS 250S Blade Video Server Read the following information to familiarize yourself with the AXIS 250S Blade video server making particular note of where the connectors and indicators are located: Control Button See the AXIS 250S User’s Manual for information on the use of the control button.
AXIS 250S Blade - Rack Solution Installation Guide AXIS 250S Blade 1 Switch - for selecting 75 ohm video termination (for BNC). By default set to ON. 1 2 Bus Connector - connected to the I/O terminal block connector at the back of the rack.
AXIS 250S Blade - Rack Solution Installation Guide The I/O Terminal Block Axis Blade Video Servers connect to an I/O terminal block used for transmitting data over multi-drop communication lines: • RS-485 Pan/Tilt devices • RS-232 Pan/Tilt devices • External triggering (typically associated with CCTV equipment) The Axis Blade Video Servers support several Pan/Tilt device drivers that are available from the Axis Web site at www.axis.
AXIS 250S Blade - Rack Solution Installation Guide Connecting the video server to the rack Please read through the instructions below before beginning the installation. 1. Connect the power cable to the power connector on the rack. Make sure that the green power indicator is lit. Power Indicator 2. Note the Serial number (S/N) on the front panel on the video server. You need to know this to set the IP address. 3.
AXIS 250S Blade - Rack Solution Installation Guide Technical Specifications The following specifications are applicable for the complete Axis Rack Mounted Video Server Solution i.e. an AXIS Video Server Rack with a mounted AXIS 250S Blade Video Server.
