User`s manual
Table Of Contents
- AXIS 2460 Network DVR
- About this document
- Product Overview
- Description
- Checking The Hardware Inventory
- Installing the AXIS 2460 Network DVR
- Connecting and Configuring Cameras
- Setting up Events and Alarms
- Working with Recordings
- System Options
- The Factory Default Settings
- Appendix A - Recording Storage and Reduction
- Appendix B - The LED Indicators
- Appendix C - Troubleshooting
- Appendix D - Other IP Setup Methods
- Appendix E - Updating the Firmware
- Appendix F - Installing Hard Disks
- Appendix G - Unit Connectors
- Appendix H - Technical Specifications
- Index
AXIS 2460 User’s Manual Installing Hard Disks
63
7. Replace the cover and screw it back into place. Set the main power switch to I. The
AXIS 2460 will now automatically detect and format the new disk(s).
Note: If the disk you installed has been used previously (a valid partition table will be detected), it will
not
be formatted. In this case the disk must be formatted manually, either by selecting Clean
from the Maintenance menu, which formats all the connected disks, or by formatting the indi-
vidual disk from the Maintenance - Advanced menu.
Any disk errors in the AXIS 2460 are indicated by the Disk LED on the front panel. This
will flash red if one of several installed disks is not functioning, and it will show a solid red
if none of the disks are functioning.