Instruction manual

Configuring the Video Server AXIS 2411 Admin Manual
16
Important!
Resetting to the Factory Default Settings
In certain circumstances, it may be necessary to reset to the Factory Default settings for
your AXIS 2411. This is performed by clicking Admin =>Factory Default in the web
interface.
An alternative way to perform a factory default is by using the Control Button. The
Control Button is located next to the three LED indicators.
Follow the instructions below to reset to the product factory default settings, using the
Control button:
1. Switch off the AXIS 2411 by disconnecting the power cable.
2. Using a suitably pointed object, press in and keep the Control Button pressed.
While the button is pressed, reconnect the power cable.
3. Keep the button pressed until the Status Indicator displays yellow (note that this may take up
to 15 seconds). Now release the Control Button. When the Status Indicator changes to green
(which may take up to 60 seconds) the AXIS 2411 will then have been reset to the original
factory default settings.
Note:
The AXIS 2411 supports the two most common video standards - NTSC and PAL.
NTSC delivers 525 lines of resolution at 60 half-frames per second and is the common standard in the
United States; whereas PAL delivers 625 lines at 50 half-frames per second and is the dominant video
standard in Europe.
Resetting to the factory default settings will cause all parameters (including the IP address) to be reset.
Refer to Installation, on page 7, or Other IP Setup Methods, on page 18, for information on how to set
the IP address.