Instruction manual

AXIS 2400+/2401+ Admin Manual Installing on a Network
9
Installing on a Network
• Quick installation - Follow the instructions below to quickly install on an Ethernet network.
• Easy installation - See Using the AXIS IP Installer, on page 36.
• Macintosh users - Please refer to Notes for Macintosh Users, on page 35.
❸
Using an appropriate method for your operating system, assign your product with a unique IP
address from a computer on your network, as follows:
Note: In some Unix systems, the arp command can be located in a directory that is not on the
command path.
You will now see ‘Request timed out...’ messages repeatedly returned in the window.
❷Note the Serial number on the
underside of the unit. You need to
know this to set the IP address.
❶Connect the video output of your camera(s) to the AXIS
2400+/2401+ video port(s) using standard 75 Ohm coaxial video cable,
terminated with a BNC-connector. If your camera is supplied with a
standard phono-type (RCA) connector, use a BNC-to-RCA converter.
Serial number same as
MAC/Ethernet number; e.g.
00408c100086 =
00-40-8c-10-00-86
Windows only - Start a DOS window and type these commands:
Syntax:
arp -s <Server IP address> <Ethernet address> <my PC IP address>
ping -t <Server IP address>
Example:
arp -s 172.21.1.200 00-40-8c-10-00-86 172.21.1.193
ping -t 172.21.1.200
UNIX only - Type this in your command line:
Syntax:
arp -s <IP address> <Ethernet address> temp
ping <IP address>
Example:
arp -s 172.21.1.200 00:40:8c:10:00:86 temp
ping 172.21.1.200
❹Connect an Ethernet cable to the AXIS
2400+/2401+ and attach it to the network.
Network socket
RJ-45 connector