Instruction manual

AXIS 2400 Administration Manual Using the Video Server
37
Camera Positioning
Although very similar, the navigational functionality is slightly different for each of the available
pan tilt drivers. The table below describes the basic positioning methods, and the level to which
these are supported by the drivers available from the Administration pages:
Camera Zoom
In a fashion similar to that provided for positional control, the degree of camera zoom is controlled
by clicking a scaled toolbar that represents the full tele-zoom potential for the selected device.
Click the left or right arrows within the toolbar for stepped increases for Wide and Tele zoom
respectively. Clicking anywhere along the toolbar gently adjusts the level of camera zoom by a
variable value predetermined by the device.
Note: Variable zoom control is not supported by the Pelco and Ernitec drivers
Defining Preset Positions
If your Administrator(s) has granted user(s) with Select Preset camera positioning rights, you can
also control and record the camera the camera angle and create up to twenty preset positions that
can be re-established at any time.
Follow the instructions below to define a preset a position:
1. Click the Preset Position button. An image taken from the selected source - at its current
position - is displayed in a new window.
2. Using the Pan Tilt and Zoom control bars, move the camera to the desired position.
3. Enter a descriptive name in the Current Position field.
4. Click Save to register the new preset position with the AXIS 2400 and then check that the
entered name is included in the Preset Positions drop-down list.
5. Click Remove only
if you want to remove this or any other preset position in the list.
Positioning method Sony Canon Videmech Ernitec Pelco
Step: Click the left, right, up or down arrows
within the positional toolbar to move the selected
camera in 5
o
steps (approx) in the chosen direction.
Yes Yes Yes Yes Yes
Smooth: Each positional toolbar represents the full
viewing angle for the selected camera.
Click anywhere along the toolbar to gently travel the
camera to its equidistant position.
Yes Yes Yes No No
Click in picture: Click directly in the picture to
define the central position of the selected camera.
Yes Yes Yes No No
Home: Click to move the camera to its home
position, as defined by the pan tilt device.
Yes Yes Yes No No