User`s manual

Status
indicator
Zoom puller
(Tele/wide)
Focus puller
DC-Iris
Serial number
on underside
label
DC-Iris control cable
DC-Iris
control cable
Power adapter
connector
RS-232
connector
Network
(also PoE)
connector
Power and
Reset/Control
button
Audio out
Audio in
connector
10-pin I/O terminal
Power connector
block
network indicators
AXIS 223M - Product Features
6
Overview
Power adapter connector - for connection of the PS-K power adapter (included).
I/O connector - The I/O terminal connector provides the physical interface to one solid state relay output, two
digital photo-coupled inputs, RS-485 and an auxiliary connection point for DC power. For more information,
see
Unit Connectors, on page 34.
Network connector - The AXIS 223M connects to the network via a standard network cable, and automatically
detects the speed of the local network segment (10BaseT/100BaseTX Ethernet). This socket can also be used to
power the AXIS 223M via Power over Ethernet (PoE). The camera also negotiates the correct power level when
using PoE.
Audio Output - Audio output (line level), which can be connected to a public address (PA) system or an active
speaker with a built-in amplifier. A pair of headphones can also be attached. A 3.5mm audio connector must be
used for the audio out.
Audio Input - One 3.5mm input for a mono microphone, or for line-in mono signal (only the left channel is
used from a stereo signal).
RS-232 Connector- Single 9-pin D-SUB RS-232 connector, max 115 kbit/s, half-duplex.
Serial Number - This number is used during installation.
Reset/control Button - Press this button to install using the AXIS Internet Dynamic DNS Service (see the
installation guide) or to restore the factory default settings, as described in
Advanced, on page 32.
LED Indicators - After completion of the startup and self test routines, the multi-colored Network, Status, and
Power LED indicators flash as follows:
Network Green Steady for connection to 100 Mbit/s network. Flashes for network activity.
Amber Steady for connection to 10 Mbit/s network. Flashes for network activity.
Unlit No connection
Note: The Network LED can be configured to be unlit during normal operation. See the online help files for more informa-
tion. Go to Setup > System Options > LED settings.
Status Green Shows steady green for normal operation.
Note: The Status LED can be configured to be unlit during normal operation, or to flash only when the camera is accessed.
See the online help files for more information. Go to Setup > System Options > LED settings
Amber Steady during startup, reset to factory default or when restoring settings.
Red Slow flash for failed upgrade.
Power Green Normal operation.
Amber Flashes green/amber during firmware upgrade.
LED Color Description