User`s manual

48
AXIS 223M - System Options
The default information level for the Access Log is set to Critical & Warnings. However, in
an error situation and when requesting support, set it to the lowest information level
Critical & Warnings & Info.
For the Log Level for
Email, select from the drop-down list the level of information to
send as email and enter the destination email address.
Advanced
Scripting is an advanced function that provides the means for customizing and using
scripts.
Caution! - The scripting function is a powerful tool. Improper
use may cause unexpected
behavior or even loss of contact with the unit. If a script does cause problems, reset the
unit to its factory default settings (in which case, a previously saved backup file will be
useful for returning the unit to its latest configuration). Axis recommends that you do not
use this function unless you fully understand its consequences. Axis support provides no
assistance for customized scripts. For more information, please visit the Developer pages at
www.axis.com/developer
Plain Config - thi
s function is for the advanced user with previous experience of
configuring Axis cameras. All parameters can be set and modified from this page. Help is
available via the links on the standard setup pages.
About
Third Party Software Licenses - click View licenses for a list of the licensed software used
in the AXIS 223M Network Camera.
Resetting to the factory default settings
To reset the camera to the original factory default settings, go to the System Options >
Maintenance web page (as described in Maintenance, on page 46) or use the Con
trol
button (see the illustrati
on on page 6) as described below:
Using the Control Button
To reset the camera to the factory default settings using the Control Button:
1. Disconnect the power adapter, or the network cable if using PoE.
2.
Press and hold the Control button while reconnecting power.
3. Keep the Control button pressed until the Status Indicator color changes to
amber (which may take up to 15 seconds).
4. Release the Control button.
5. When the Status Indicator changes to Green (which may take up to 1 minute), the
process is complete and the camera has been reset. The unit will now have the
default IP address 192.168.0.90 if you are not using a DHCP server.