Installation guide

AXIS 2120 Installation Guide - English Page 4 of 5
Refining the Dial-up Networking Properties...
Having created the Dial-up connection for your AXIS 2120, follow the steps below to refine the
connection properties:
Initiating the Dial-up Connection...
Important!
Please ensure that the Null Modem Cable is correctly installed and that the relative connection properties are cor-
rectly configured prior to initiating a Dial-up connection. Step-by-step instructions on how to do this are provided
on the preceding pages of this section
Click the Server Types tag. From
the drop-down dialog, select PPP
as the Type of Dial-Up Server.
From the Dial-up Networking dialog, right click the
dedicated Dial-up connection previously created for
you camera (AxisCamera was the connection created
used in this and previous examples). Select Properties.
In the Advanced options field,
check Enable software compression.
All other checkboxes should
remain unchecked.
In the Allowed network protocols field,
check the TCP/IP checkbox. NetBEUI
and IPX/SPX checkboxes should remain
unchecked.
Check the Use IP header
compression and Use default
gateway on a remote network
checkboxes. Click OK.
Click the Scripting tag and ensure that the Start
terminal screen minimized checkbox is checked.
Click OK to exit Dial-Up Networking Properties.
Click TCP/IP settings and then
check the Server assigned IP address,
and Server assigned name server
addresses radio buttons.
7
Double click the Dial-Up
connection icon that was
previously created for your AXIS
2120. AxisCamera was used in this
and previous examples.
Double click My Computer and
then double click the Dial-Up
Networking dialog.
Enter a Username and
Password using the default
root and pass respectively.
Click Connect to initiate
the Dial-Up connection.
2120ig_master.fm Page 4 Monday, July 3, 2000 4:33 PM