User`s manual

8
AXIS 210A/211A - Introduction
Power Connector - For connection of the PS-K power adapter (included).
I/O Terminal Connector - The I/O
terminal connector provides the physical interface to
one transistor output, one digital input and an auxiliary connection point for DC power.
For more information, see The I/O Terminal Connector,
on page 55.
Note:
Depending on the product version of your AXIS 210A/211A, you will see one of two different types of I/O
terminal connectors. See The I/O Terminal Connector, on page 55.
Network Connector - The camera connects to the network via a standard network
connector. The camera detects the speed of the local network segment
(10BaseT/100BaseTX Ethernet). This socket can also be used to power the AXIS 210A and
the AXIS 211/211A via PoE (Power over Ethernet).
Audio Output - Audio
output (line level), which can be connected to a public address (PA)
system or an active speaker with a built-in amplifier. A pair of headphones can also be
attached. A stereo connector must be used for the audio out.
External Microphone/Line Input - One 3.5mm
input for a mono microphone, or for
line-in mono signal (only the left channel is used from a stereo signal).
Serial Number - This n
umber is used during installation.
Control Button - Press
this button to install using the AXIS Internet Dynamic DNS Service
(see page 46) or to restore the factory default settin
gs, as described in Resetting to Factory
Default Settings, on page
53.
LED Indicators
After completion of the startup and self test routines, the multi-colored Network, Status,
and Power LED indicators show as follows:
Network Amber Steady for connection to 10 Mbit/s network. Flashes for network activity.
Green Steady for connection to100 Mbit/s network. Flashes for network activity.
Unlit No wired network connection.
Status
Green Shows steady green for normal operation. Can be configured to flash green at intervals
whenever t
he camera is accessed.
Unlit When configured for “no flash” on camera access.
Amber Steady during startup, reset to factory default or when restoring settings.
Red Slow flash for failed firmware upgrade.
Power Green Normal operation.
Amber Flashes green/amber during firmware upgrade.