User`s manual

8
AXIS 210/211/211A - Product Features
Network Connector - The camera connects to the network via a standard network
connector. Supporting NWAY, the camera detects the speed of the local network segment
(10BaseT/100BaseTX Ethernet). This socket can also be used to power the AXIS 211/211A
via PoE (Power over Ethernet).
Audio Output - Audio output (line level), which can be connected to a public address (PA)
system or an active speaker with a built-in amplifier. A pair of headphones can also be
attached. A stereo connector must be used for the audio out.
External Microphone/Line Input - One 3.5mm input for a mono microphone, or for
line-in mono signal (only left channel is used from a stereo signal).
Serial Number - This number is used during installation.
Control Button - Press this button to install using the AXIS Internet Dynamic DNS Service
(see
page 11) or to restore the factory default settings, as described in Resetting to the
Factory Default Settings, on page 41.
LED Indicators
After completion of the startup and self test routines, the multi-colored Network, Status,
and Power LED indicators flash as follows:
Network Amber Steady for connection to 10 Mbit/s network. Flashes for network activity.
Green Steady for connection to100 Mbit/s network. Flashes for network activity.
Red Flashes rapid red, together with the Status indicator, for hardware error.
Unlit No connection.
Status
Green Shows steady green for normal operation. Can be configured to flash green at intervals
whenever the camera is accessed. See the online help for more information.
Unlit When configured for “no flash” on camera access.
Amber Shows steady amber during reset to factory default or when restoring settings.
Red Slow flash for failed upgrade (see Emergency Recovery Procedure, on page 43).
Rapid flash, together with the Network indicator, for hardware error.
Power Green Normal operation.
Amber Flashes green/amber during firmware upgrade.