User`s manual

User’s Manual Section 7: Upgrading the Software

Upgrading the

AXIS OfficeBasic

Follow the instructions below to upgrade the AXIS OfficeBasic

flash memory with an updated firmware version:

1. Log in to the AXIS OfficeBasic with the command:

ftp <host name>, or ftp <IP address>

2. You will be prompted for user id and password. Use the user id

root, which has the default password pass.

3. Type the command

binary to change to binary transfer mode.

4. Type the command

put <software name> flash, where

<software name> is the name of the new print server software,

e.g.

office_6xx.bin

5. Wait for the Flash loading operation to finish. This normally

takes 1 to 4 minutes. The unit automatically restarts with the

new print server software.

6. Log out using the command

quit, bye or exit depending on

your FTP version.

Notes: ❏ If the upgrading process fails, just repeat the instructions

presented above.

❏ If you lose contact with the AXIS OfficeBasic after an upgrade

failure, just restart the AXIS OfficeBasic to restore contact.

❏ Should the network diode flash at half a second intervals, the

AXIS OfficeBasic cannot process any print jobs. In order to

leave this state, you must repeat the instructions presented

above.