User`s manual

Section 4: Printing from Windows NT 3.5 (TCP/IP) User’s Manual

Section 4 Printing from Windows NT 3.5 (TCP/IP)

This section describes how to install the AXIS OfficeBasic for

TCP/IP printing on Windows NT3.5x clients.

Before you begin ❏ Make sure that the TCP/IP protocol is enabled on your

Windows client.

Installation Steps To complete the installation you need to perform the following

steps:

• Physically connect the AXIS OfficeBasic to your network and

assign an ip address to the print server. See Hardware

Installation and IP address assignment, on page 12.

• Install the AXIS Print Monitor software on your client. Please

refer to page 33.

• Integrating the AXIS OfficeBasic in your network and

installing the TCP/IP printer ports on your client. Please refer to

page 35.