User`s manual

Section 2: Hardware Installation and IP address assignment User’s Manual
12
Section 2 Hardware Installation and IP address
assignment
In order to set up you print server and make it available for use on
user’s workstations, follow the instructions described here:
Connect the Hardware, on page 12
Assign an IP Address to the Print Server, on page 13
Adding a Network Printer to your workstation, on page 19
Connect the Hardware 1. Make sure that your printer is switched off and that the print
server’s Power Adapter is disconnected
.
2. Locate the serial number, found on the underside label of the
print server, and write it down. You will need this number to
configure the print server. Example: S/N: 00408c181cf0
3. Connect the printer directly to the LPT port or using the printer
cable .
4. Connect the print server to the network using a twisted pair
category 5 cable, 10baseT or 100baseTX.
5. Switch on the printer and make sure it is ready for use.
6. Connect the Power Adapter to the print server. The power
indicator will light up. When the network indicator starts to
flash, the print server is correctly connected to the network.
7. Wait 1 minute. Press the test button on the print server once to
print a test page. The test page includes a list of the most
important parameters.