User`s manual

Section 5: Configuration Parameters
50 AXIS AFP IOP User’s Manual
Full Page Printing Full Page Printing ..................................................... [Full Page Printing]
This option makes it possible to use the so called “Edge to edge” printing
facility.
IPDS Parser syntax (with default setting):
FULL_PAGE_PRINTING = 0;
Test Page Test Page............................................................[Testpage at Power ON]
Note: This option is only located under "Printer Options" in the utility
program. In the Lexmark front panel menu the same option is found
under [TEST PAGE] in the [TEST OPTIONS] menu.
Setting the Start Testpage option to one will enable printing of a test page
each time the interface is turned on.
IPDS Parser syntax (with default setting):
TEST_PAGE = 0;
Note: The frontpanel menu [Test Page] has as an additional item:
This value can only be selected from the front panel as it is disabled at
power OFF.
•0 [No] This setting gives the same printout as with older versions. If you
have an Optra printer and if your printer has RIP code level 31.01
or higher (also known as Base Code), and engine code 43.42, you
may find this option useful.
1 [Yes] The AFP IOP interface will use the so called “Edge to edge” facility,
which means that you will get a printout with 1/10 of an inch
unprintable margin around the page and that the contents of the
page will be compressed about 2% in all directions..
•0 [Disable] No test pages.
1 [Enable] Print test page at start.
[Continuous Test Page].