User`s manual

Section 5: Configuration Parameters

AXIS AFP IOP User’s Manual 29

C15 Early Print Complete Response Timing......................[c15 Print Release]

This is used to control when the printer will acknowledge a Form Feed

(both an automatic FF and a valid FF control code). This option is only

valid for non-IPDS mode.

Note: This option is inverted compared to the 3812/3816 printers. On the

3812/3816 C15 = 0 means that the FF will not acknowledge until

printing is physically completed.

IPDS Parser syntax (with default setting):

COAX_C15 = 0;

C16 Automatic Function at End of OILC Job............... [c16 At end of OILC]

Used in DSC/DSE modes only.

IPDS Parser syntax (with default setting):

COAX_C16 = 0;

• 0 [Processing] The FF will be acknowledged when the page has been transferred

to the page buffer in the printer. With this setting you can achieve

the maximum throughput, but you may lose data on an IR or if the

printer loses power.

1 [Printing] For DSC/DSE print the FF will not be acknowledged until the print

is physically completed. For LU-1 (SCS) print the printer will func-

tion as if this option was set to zero provided that the chaining

techniques are not used (Please refer to PCIA address X'0017' Bit

number 1 & 2). However, if the FF (automatic or as control code)

is found in a

Last

Only

segment, the FF will not be acknowledged

until the print is physically completed.

• 0 [No Auto Func.] The setting of C24 controls how the printer handles the end of

a print-order.

1 [Auto Function] Form feed is executed after the print buffer has completed a

local copy job.