Operating instructions

•
12
The motor features a sliding rod mount slot so the motor can be height adjusted
to achieve convenient mesh with the lens. There are 15 and 19mm rod mounts
available. Slide the mount in to the slot, either way up (the clamp can be used
upside down so that the tightening knob is in a convenient place.) It is not
necessary to clamp the rod mount too tightly, nger tight will do. Over tightening
can cause damage to the clamp. Please be aware if the motor swings away from
the lens easily, it may be the entire rod rotating and not the motor clamp slipping.
Check that the rod is not rotating in whatever clamp it is held in before tightening
the motor clamp.
Select the correct drive gear and install onto the motor hub by removing the hub
screw and sitting the gear on over the three locate pins. Replace the screw and
tighten.