Operating instructions

Getting Started

DO NOT DO THIS IF YOU ARE USING A ENDLESS INFINATE ROTATING DSLR LENS.

SEE THE INFINATE ROTATION SECTION OF THIS MANUAL FIRST.

The motor will calibrate torque and end limits. If there is no hand unit present,

the motor will sit at the end of the lens and await signal from a hand unit. If the

hand unit is switched on and is operating on the right frequency (see

frequency changing section of this manual) then the system will go into live

control mode.

If the receiver unit looses power for less than ve minutes (a battery change for

example) then it will not require recalibration. Please remember that if the

motor is removed and replaced, or the lens is changed a recalibration must be

performed for proper operation. To do this, the calibrate button on either the

receiver or hand unit can be used.

Plug the motor into the receiver unit. The display will ash

U.C for uncalibrated. Mesh the motor with the lens and

press and hold the calibrate button and the auto calibrate

sequence will initiate.

UNCALIBRATED