Datasheet

AXIS Q6032 PTZ Dome Network Camera
Video and Audio
For more information about t hese settings, please see the online help .
Audio Input
An external microphon e or a line source can be connected to the product’s Audio-in connector. Config u re the audio input s ettings
under Video & Audio > Audio Settings.
Note
A multi-connector cable (available from Axis; M ulti-Connector Cable (sold separately)) is required when connecting external
audio equipment to the Axis product.
Source - Select Microphone for an external microphone or Line for a Line in device, e.g. a n audio mixer for multiple microphones or
a microphone with a built-in amplifier.
Microphone power - Microphone po wer should only be used with electric microphones that have no battery and when using the
internal microphone. This setting should not be enabled when using a dynamic or battery powered microphone.
Input gain - Control the volume (dB Full Scale) of the audio input. If the sound is too low, choose a higher dB. If the sound is too
high, choose a lower dB. The Level bar gives a visual representation of the audio signal in dB Full Scale.
• Green — the signal is at a good level.
• Yellow — the signal is becoming distorted.
• Red — The signal is distorted
Encoding - Select digital audio encoding format.
• G711 is an unlicensed standard codec that is useful when integrating audio into a VoIP system.
• G726 is an unlicensed speech codec that is most commonly used within the security industry.
• ACC requires a license for both encoding a nd decoding. AAC is the least complicated and most widely use d codec. If
achieving the best poss ible audio quality is a priority, AAC is the rec
ommended codec to use. An AAC license is included
in the Axis product.
Sample rate - The number of tim es per second the sound is sampled. A higher sample rate will provide better a udio quality, but
also requires a greater bandwidth.
Bit rate - Set the required bit rate depending on the selected encoding. A highe r bit rate will give better audio quality. A lower bit
rate may have latency or delay, but will require less bandwidth.
For more information about t hese settings, please see the online help
.
Audio Output
An external speaker can be connected to the product’s Audio-out connector. Configure the a udio output settings under Video
&Audio> Audio Settings.
Note
A multi-connector cable (available from Axis; M ulti-Connector Cable (sold separately)) is required when connecting external
audio
equipment to the Axis product.
Output gain - Control the volume (dB Full Scale) o f the line audio output. The output can be used with high impedance headphones or
connected to another amplifier with speakers. If the sound is too low, choose a higher dB. If the sound is too high, choose a lower dB.
19