Datasheet

7
Axis Rack Mounted Video Server Solution
ENGLISH
AXIS blade video servers
S/N - (serial number) is identical to the unit’s MAC/Ethernet address,
e.g. 00408C1A2B3C = 00-40-8C-1A-2B-3C.
P/N - is the product’s model number.
Bus Connector - This is the physical interface to the I/O terminal connector on the rack.
DIP Switches (4-port models) - Each video input has a corresponding line termination
DIP switch. Axis blade video servers are supplied with the line termination enabled for each
input; i.e. with the DIP switches set to ON (down position). To connect the video server in parallel
with other equipment, disable the input termination by setting the corresponding DIP switch to
OFF (up position). Failure to do so may affect the image quality negatively.
DIP Switches (1-port models) - These models can accommodate either composite or Y/C
video. The type to use is determined by the DIP switch settings. 1-port AXIS blade video servers
are supplied configured for composite video input, as shown in the table below
.
Switch
1 2 3 4
Description
75 ohm video in
termination
75 ohm video out
termination
Connects video in
and video out
Not used
Composite video
input
on off on n/a
Y/C video input
on on off n/a
Bus
Connector
DIP Switches
S/N & P/N label
4 Video inputs