Datasheet

9
AXIS 292 - General page
General page
This page provides settings for configuring the start up
mode, alarm notification, video and audio output.
Connect at startup - When
set to Yes, the AXIS 292
will automatically connect to the first video source in
the video source list at startup. When set to No, it will
stay disconnected and wait for user input or alarms.
Sequence mode -
When set to Auto, the AXIS 292
automatically cycles through the video sources in the
list on the Video Sources page. In Manual mode, the
next source is displayed when the video select button
is pressed. See page 14 for more information.
Video select button - Enables
or disables the video select button on the front panel of the AXIS 292.
Alarm
The AXIS 292 can automatically switch to a video source that sends an alarm. See page 15 for more
information.
Video Out
TV System - Select the TV system type to use. Most western European countries use the PAL system, whereas
the system in the United States is NTSC.
Margin adjustment - As video monitors
often use too much of the available screen area, some parts of the
monitored scene might not be visible. To correct this, the AXIS 292 allows the margin to be adjusted on all 4
sides, so that the image is forced more towards the center of the screen. A margin is added by default, and
values (number of TV-lines) in the following ranges are allowed:
• PAL
- Vertical: 0 till 575, Horizontal: 0 till 719. The sum of the vertical values cannot exceed 575.
The sum of the horizontal values cannot exceed 719.
• NTSC- Vertical: 0 till 479, Horizontal: 0 till 719. The sum of the vertical values cannot exceed 479.
The sum of the horizontal values cannot exceed 719.
Audio out
Volume (0-100) - Set the level of the audio output on the AXIS 292. The default value is 50.