Printer User Manual

Section 6: Setup for Unix systems
50 Axis NPS 530/532 User’s Manual
Set up and attach a print queue
The final step is done using the axinstall script, which is up-loaded from
the NPS 530/532 to your host using FTP. You don’t need any technical
knowledge about your Unix system; axinstall will automatically detect
your system’s characteristics, and guide you through the setup procedure.
Below is a list of Unix systems that are supported by axinstall:
If your particular system isn’t listed, axinstall tries to use one of the
generic Unix systems (BSD, SYS V R3 or SYS V R4). If axinstall fails to
recognize your system, complete the setup manually as described in the
Axis NPS Print Server Technical Reference.
Up-load axinstall 1. Log in to the NPS 530/532 with the command ftp <host name>,
where host name is the name assigned in your system host table (e.g.
salesdept). You will be prompted for user id and password. Enter root as
user id, and pass as password.
2. Up-load the script using the command get axinstall.
3. Log out using quit, bye or exit (depending on your FTP version).
*
BSD
(Berkley Unix)
IRIX
(Silicon Graphica, SGI)
SunOS 4
(Sun BSD, Solaris 1.x)
BOS
(BULL DPX 2)
ULTRIX
(Digital Equipment, DEC) *
SYS V R4
(UNIX System V Release 4)
DEC OSF/1
(Digital Equipment, Alpha)
SunOS 5
(Sun SYS V, Solaris 2.x)
FreeBSD
(Berkley Unix)
HP-UX
(HP 9000)
*
SYS V R3
(Unix System V Release 3)
AIX
(IBM RS/6000, BULL DPX 20)
SCO
(Santa Cruz Operation)