User Guide

NetWare

UNIX

Windows

OS/2

Macintosh

Section 3: Basic Installation AXIS 5400 User’s Manual

Using

AXIS IP Installer

Follow the instructions below to set the IP address of your AXIS 5400

using the AXIS IP Installer:

Important! ❏ You should not use AXIS IP Installer to set the IP address of the

AXIS 5400, if you have an active DHCP server in your network.

1. Download the AXIS IP Installer to your host. The software is

available on the AXIS Online CD and on the Axis home page at

http://www.axis.com/.

2. Connect the AXIS 5400 to the network. Note the serial number

that is located on the underside label of the AXIS 5400. You will

need it in the proceedings steps.

3. Start the AXIS IP Installer.

4. Click the serial number of your AXIS 5400 that appears in the

server list.

5. Enter the desired IP address in the designated IP address field and

click the Set IP address button.

6. The IP setting process will take approximately 10 to 40 seconds.

Click OK in the confirmation box that appears when the IP

address has been set.

Notes: ❏ AXIS IP Installer uses the BOOTP and DHCP protocols to

communicate with the AXIS 5400. Make sure that at least one of

these protocols is enabled in your print server.

❏ Restart your AXIS 5400, if it does not show up in the server list.