User Guide
Table Of Contents
- An Introduction to the AXIS 2420
- Physical Description
- Checking The Hardware Inventory
- Installing on a Network
- Installing via a Modem
- Focusing Your Camera
- Configuring Your Camera
- The Factory Default Settings
- Choosing Your Application
- The AXIS 2191 Audio Module
- Appendix A - Troubleshooting
- Appendix B - Other IP Setup Methods
- Appendix C - Lenses and Advanced Focusing
- Appendix D - Customizing Your Camera
- Appendix E - Updating the Firmware
- Appendix F - The Unit Connectors
- Appendix G - High-Speed Services
- Appendix H - Technical Specifications
- Physische Beschreibung
- Überprüfen des Lieferumfangs
- Installieren in einem Netzwerk
- Anschließen an ein Modem
- Scharfeinstellung der Kamera
- Werkseitige Standardeinstellungen
- Description du Materiel
- Vérification de la liste du matériel
- Installation sur un réseau
- Installation par l’intermédiaire d’un modem
- Mise au point de votre caméra
- Restauration des paramètres d’usine par défaut
- Descripción física
- Comprobar el inventario de hardware
- Instalación de la cámara a una red
- Instalación de la cámara a un módem
- Enfocando la cámara
- Incluir los parámetros por defecto
- Index
AXIS 2420 User’s Manual Lenses and Advanced Focusing
59
Adjusting the Back Focus
Your AXIS 2420 is supplied with the back focus roughly set to accommodate a reasonable
level of focus throughout the complete focusing range. However, if you are dissatisfied
with the quality of focusing at a specific plane (or at several planes) within the focusing
range, you may need to make some fine adjustments to the back focusing of the lens. This
is performed by adjusting the focus and zoom rings of the camera lens, as described below:
Procedure
1. With the Focus Ring set to the Far-focus (F, ∞) position, aim the camera at a subject
over 30 metres away.
2. Set the lens assembly to wide angle, and adjust the back focus by loosening the Lock
Ring and then turning the lens assembly. Continue to turn the lens assembly until you
achieve optimum image clarity
3. Check that you obtain sharp pictures at various zoom grades and various distances.
Note: If possible, it is better to perform this adjustment in low light conditions, or with a filter covering
the front optic. This will ensure the iris is fully open to give the smallest depth of field, and there-
fore the best result.