User Guide
Table Of Contents
- An Introduction to the AXIS 2420
- Physical Description
- Checking The Hardware Inventory
- Installing on a Network
- Installing via a Modem
- Focusing Your Camera
- Configuring Your Camera
- The Factory Default Settings
- Choosing Your Application
- The AXIS 2191 Audio Module
- Appendix A - Troubleshooting
- Appendix B - Other IP Setup Methods
- Appendix C - Lenses and Advanced Focusing
- Appendix D - Customizing Your Camera
- Appendix E - Updating the Firmware
- Appendix F - The Unit Connectors
- Appendix G - High-Speed Services
- Appendix H - Technical Specifications
- Physische Beschreibung
- Überprüfen des Lieferumfangs
- Installieren in einem Netzwerk
- Anschließen an ein Modem
- Scharfeinstellung der Kamera
- Werkseitige Standardeinstellungen
- Description du Materiel
- Vérification de la liste du matériel
- Installation sur un réseau
- Installation par l’intermédiaire d’un modem
- Mise au point de votre caméra
- Restauration des paramètres d’usine par défaut
- Descripción física
- Comprobar el inventario de hardware
- Instalación de la cámara a una red
- Instalación de la cámara a un módem
- Enfocando la cámara
- Incluir los parámetros por defecto
- Index
Lenses and Advanced Focusing AXIS 2420 User’s Manual
54
Appendix C - Lenses and Advanced Focusing
Your camera was supplied either without a lens (AXIS 2420), or with a DC-Iris lens (AXIS
2420 W/Lens). Either model can be fitted with any standard CS/C lens. The DC-Iris support
included with the AXIS 2420 will drive any standard DC-Iris lens.
Fitting a Lens
Note: The AXIS 2420 is equipped with a CS-mount, so any standard CS lens can be fitted directly. To
mount a C-type lens, a CS-C adapter must also be used. The adapter effectively moves the lens
5mm away from the camera’s CCD.
Follow the instructions below to fit any C or CS type lens:
1. C-lens only: Attach the new lens to a CS-C Adapter.
2. Screw the lens onto the AXIS 2420. If applicable, adjust the iris according to the
prevailing light conditions.
3. Referring to Focusing Procedure, on page 56, adjust the camera focus.
4. Adjust the DC-Iris settings. See page 57.
5. Refresh your browser and check the results from the camera’s Home Page.
Caution!
Exposing your camera to bright sunlight may cause permanent damage to the CCD if you:
• use a non-DC Iris lens, or
• select anything other than DC-Iris in the Exposure Control settings of the Image - Advanced page.
Axis consequently advises extreme caution when fitting a lens to your AXIS 2420 and/or when using the
Image - Advanced settings. Damage caused to the AXIS 2420 through overexposure to direct sunlight or
halogen light is not covered under the product warranty.