User Guide
Table Of Contents
- An Introduction to the AXIS 2420
- Physical Description
- Checking The Hardware Inventory
- Installing on a Network
- Installing via a Modem
- Focusing Your Camera
- Configuring Your Camera
- The Factory Default Settings
- Choosing Your Application
- The AXIS 2191 Audio Module
- Appendix A - Troubleshooting
- Appendix B - Other IP Setup Methods
- Appendix C - Lenses and Advanced Focusing
- Appendix D - Customizing Your Camera
- Appendix E - Updating the Firmware
- Appendix F - The Unit Connectors
- Appendix G - High-Speed Services
- Appendix H - Technical Specifications
- Physische Beschreibung
- Überprüfen des Lieferumfangs
- Installieren in einem Netzwerk
- Anschließen an ein Modem
- Scharfeinstellung der Kamera
- Werkseitige Standardeinstellungen
- Description du Materiel
- Vérification de la liste du matériel
- Installation sur un réseau
- Installation par l’intermédiaire d’un modem
- Mise au point de votre caméra
- Restauration des paramètres d’usine par défaut
- Descripción física
- Comprobar el inventario de hardware
- Instalación de la cámara a una red
- Instalación de la cámara a un módem
- Enfocando la cámara
- Incluir los parámetros por defecto
- Index
AXIS 2420 User’s Manual Other IP Setup Methods
53
Notes for Macintosh Users
The AXIS 2420 supports TCP/IP over Ethernet, or PPP Modem dial-up. You must use
TCP/IP on your Macintosh network, as there is no support for AppleTalk.
When using the AXIS 2420 on a Macintosh, please observe the following points:
• The camera has a default IP address of 192.36.253.80.
• Assign a temporary IP address to a Mac workstation in the same subnet (e.g. 192.36.253.81)
and then connect to the camera.
• Run the Installation wizard and set the desired IP address for the camera.
• Reset the correct IP address for the Macintosh workstation.
• Changing the IP address for a Macintosh does not require a reboot.
Currently there are limitations in the ActiveX Support in Internet Explorer running on the
Macintosh. This results in problems when viewing live moving images. The recommended solution
for viewing Axis cameras on the Macintosh is to use Netscape.