User Guide

The Factory Default Settings AXIS 2420 User’s Manual
30
The Factory Default Settings
In certain circumstances, it may be necessary to reinstate the Factory Default settings for
your AXIS 2420. This is performed by clicking the appropriate button in the
Administration Tools, or by pressing the Control Button (see the illustration on page 9).
Follow the instructions below to reinstate the product factory default settings using the
Control Button:
1. Switch off the AXIS 2420 by disconnecting the power cable.
2. Press and hold the Control Button pressed, and reconnect the power supply cable.
3. Continue to keep the Control Button pressed until the Status Indicator displays yellow
(note that this may take up to 15 seconds), then release the Control Button. When the
Status Indicator displays green (which can take up to 1 minute) the AXIS 2420 will
then have been reset to the original factory default settings.
Note: Reinstating the factory default settings causes all parameters (including the IP address) to be
reset.