User Guide
Table Of Contents
- An Introduction to the AXIS 2420
- Physical Description
- Checking The Hardware Inventory
- Installing on a Network
- Installing via a Modem
- Focusing Your Camera
- Configuring Your Camera
- The Factory Default Settings
- Choosing Your Application
- The AXIS 2191 Audio Module
- Appendix A - Troubleshooting
- Appendix B - Other IP Setup Methods
- Appendix C - Lenses and Advanced Focusing
- Appendix D - Customizing Your Camera
- Appendix E - Updating the Firmware
- Appendix F - The Unit Connectors
- Appendix G - High-Speed Services
- Appendix H - Technical Specifications
- Physische Beschreibung
- Überprüfen des Lieferumfangs
- Installieren in einem Netzwerk
- Anschließen an ein Modem
- Scharfeinstellung der Kamera
- Werkseitige Standardeinstellungen
- Description du Materiel
- Vérification de la liste du matériel
- Installation sur un réseau
- Installation par l’intermédiaire d’un modem
- Mise au point de votre caméra
- Restauration des paramètres d’usine par défaut
- Descripción física
- Comprobar el inventario de hardware
- Instalación de la cámara a una red
- Instalación de la cámara a un módem
- Enfocando la cámara
- Incluir los parámetros por defecto
- Index
Installing via a Modem AXIS 2420 User’s Manual
14
Installing via a Modem
The information in this section describes how to connect the AXIS 2420 to a serial modem
for transmitting images over a dial-up connection.
Important!
Connecting Your Computer Using the Null Modem Cable
• Although instructions for configuring the AXIS 2420 using a null modem cable are provided below, it is
recommended that (if possible) the unit is initially installed and configured over a network.
• The information and screen examples featured within this section are specific to Windows NT. Although
similar to the Dial-Up implementations in other versions of Windows, small deviations in the dialog
instructions for other operating systems should be expected. Refer to your system information for further
information on creating a Dial-Up modem connection if you are using any other operating system.
• Windows Dial-Up Networking and TCP/IP must be correctly installed prior to commencing with the
modem cable connection. Detailed information on how to check this is provided in Windows Help.
❶ Connect the supplied Null modem cable
between the COM1 Serial Connector on the
AXIS 2420 and the COM port of your computer.
❷ Connect the power supply to the AXIS 2420
and check that the Power Indicator is lit.
❸ From the Start menu,
open the Control Panel
and double-click the
Modems icon.
❼ Select the serial port to
which your AXIS 2420 is
now connected via the Null
Modem cable. Click Next>.
❻ Select the Standard 28800
modem from the displayed
list of modems. Click Next>.
❾ Click the Properties button to finally check that the dis-
played Communications Port is set correctly; that is, set to
the same port you connected the AXIS 2420 to. Click OK.
❿ Click Close.
❺ Check the box: Don’t detect my modem,
I will select it from a list. Click Next>.
❽ A Standard 28800 modem connection is
now available for the AXIS 2420. Click Finish
to close the Install New Modem wizard.
❹ If a Standard Modem is already set up
and displayed in the Modem Properties
dialog you can proceed directly to step 8.