- AXIS User's Manual Network Camera 206

AXIS 206 - Install the AXIS 206W

Install the AXIS 206W

Before the AXIS 206W can connect to an encrypted wireless network, the wireless settings

in the camera must be configured and an IP address must be set. This is done by

connecting the camera to a computer with the help of the supplied USB cable. Follow the

instructions below.

Set up the wireless connection - Windows

1. Connect the power adapter to the camera. Press the power cable into the cable clip on

the rear panel. This will help prevent accidental cable disconnection.

2. Connect the USB

cable to your

computer and then

to the camera.

3. Open My Computer

or Windows

Explorer, and the

AXIS 206W should

be displayed as a

new drive.

4. Click on the drive

for the AXIS 206W to see the files contained in the camera.

5. Click on the file setup.exe. This starts

the AXIS Setup Tool, which lets you

configure the wireless settings.

6. Enter the name of the network (SSID) to

connect to, and optionally enable

wireless encryption. See the online help

in the setup tool for more information.

Note that any settings made here should

match those previously made in your

wireless access point.

7. Specify the type of IP address to use.

See the online help for more

information.

8. Click OK, close the AXIS Setup Tool and

disconnect the USB cable.

The AXIS 206W displays

as a drive

Online Help