User Manual
Table Of Contents
- Cover
- Section 1 Introduction
- Section 2 Installing the AXIS 240
- Section 3 Assigning an IP Address
- Section 4 Configuring the AXIS 240
- Section 5 Using the AXIS 240
- Appendix A Troubleshooting
- Appendix B The Parameter List
- Appendix C Updating the Software
- Appendix D Technical Specifications
- Appendix E The Auxiliary IO Port
- Appendix F The RS232 Serial Ports
- Appendix G Camera Applications
- Appendix H CRON Script Command Reference
Appendix F: The RS232 Serial Ports AXIS 240 Users Manual
94
5. To check that the settings have been saved, turn the modem off
and power it on again.
6. Type
ati4. You should not see your own typing at this point,
but if you do, check your modem DIP switches and make sure
that the
ate0 command was issued successfully.
The new settings dump that is displayed should be identical to those
previously saved. If it is, your modem is now ready to be connected to
the AXIS 240!
Notes:
❏ The above session was performed on a US Robotics modem.
Please be aware that the required settings for other types of
modems may differ from those defined above. Axis are currently
checking the compatibility of the AXIS 240 with other popular
modem types and will release configuration details for these
shortly.
❏ Some modem manufacturers require you to set a DIP switch to
disable command echoing. e.g. USR Sportster 28k8 modems
require DIP switch 4 to be set to the DOWN position.