User Manual
Table Of Contents
- Cover
- Section 1 Introduction
- Section 2 Installing the AXIS 240
- Section 3 Assigning an IP Address
- Section 4 Configuring the AXIS 240
- Section 5 Using the AXIS 240
- Appendix A Troubleshooting
- Appendix B The Parameter List
- Appendix C Updating the Software
- Appendix D Technical Specifications
- Appendix E The Auxiliary IO Port
- Appendix F The RS232 Serial Ports
- Appendix G Camera Applications
- Appendix H CRON Script Command Reference
AXIS 240 Users Manual Appendix F: The RS232 Serial Ports
93
Notes:
❏ Some modems are supplied with a cable equipped with 25 pin
DSUB connectors at both ends. Should you have a cable similar
to this, you will need to use a 25 pin Male - 9 pin Female 'gender-
bender' with the pin assignment detailed above. Null modem
cables will not work!
❏ Contact Axis for information about supported cellular phones and
modems.
Configuring the
Modem
Before files can be transferred from your AXIS 240, the host and
remote modems must be configured correctly.
Follow these instructions to configure a US Robotics 28k8+ modem:
1. Connect the modem to your terminal.
2. Check that the modem is responding by issuing the
at command.
3. Continue your configuration in accordance with the session
detailed below (user commands are written in
bold text):
4. To make sure that your modem reloads the established settings on
each occasion it powers up, issue the
ati4 command once the
configuration is complete.
at
OK
at&f ;load factory default settings
OK
at&b1 ;lock DTE-DCE baud rate
OK
at&h1 ;CTS handshaking on
OK
atm0 ;turn speaker off
OK
ate0 ;command echo off
Note: this inhibits the display
of entered commands.
OK
at&w ;save settings to modem
OK
---------ready ----