User Manual
Table Of Contents
- Cover
- Section 1 Introduction
- Section 2 Installing the AXIS 240
- Section 3 Assigning an IP Address
- Section 4 Configuring the AXIS 240
- Section 5 Using the AXIS 240
- Appendix A Troubleshooting
- Appendix B The Parameter List
- Appendix C Updating the Software
- Appendix D Technical Specifications
- Appendix E The Auxiliary IO Port
- Appendix F The RS232 Serial Ports
- Appendix G Camera Applications
- Appendix H CRON Script Command Reference
AXIS 240 Users Manual Section 5: Using the AXIS 240
63
In a Web browser, the page will look like this:
Note:
❏ To enable input/output operations using HTTP, the AXIS 240
must be configured properly. See Setting Up the AXIS 240 for
Pan/Tilt Connection on page 100.
CGI Parameters for
Preset Positions
For preset position requests, use this syntax:
It is also possible to use an index number instead of the preset position
name:
Note:
❏ It may take a few seconds for the camera to adjust itself to the new
position but the snapshot is taken immediately. Therefore you
need to update the snapshot in the application after a while.
http://<cameraname>/<imagefile>?cgi-bin/control?
presetposname=<position name>
http://<cameraname>/<imagefile>?cgi-bin/control?
presetposno=<1-10>