User Manual
Table Of Contents
- Cover
- Section 1 Introduction
- Section 2 Installing the AXIS 240
- Section 3 Assigning an IP Address
- Section 4 Configuring the AXIS 240
- Section 5 Using the AXIS 240
- Appendix A Troubleshooting
- Appendix B The Parameter List
- Appendix C Updating the Software
- Appendix D Technical Specifications
- Appendix E The Auxiliary IO Port
- Appendix F The RS232 Serial Ports
- Appendix G Camera Applications
- Appendix H CRON Script Command Reference
AXIS 240 Users Manual Appendix F: The RS232 Serial Ports
103
To enable HTTP input/output operations on the Pan/Tilt port,
follow these steps:
1. Click on the Settings link on the AXIS 240 Home Page. You will
be prompted to supply the username and password. By default,
these are set to
root and pass.
2. Click Pan/Tilt.
3. Click Driver. As Pan/Tilt device, select HTTP input/output
driver. Click Store driver and restart.
4. Click Port. Adjust the parameters for Baud rate, Data bit, Stop bit
and Parity. Click Store device settings.
The Pan/Tilt port is now enabled for input/output operations via
HTTP. Refer to Common Gateway Interface (CGI) parameters on
page 59 for a list of the CGI parameters you can use.
TCP Protocol
Instead of using a specific Pan/Tilt driver, the camera position can be
controlled through a TCP client application via the Pan/Tilt serial
port.
To enable TCP input/output operations on the Pan/Tilt port, follow
these steps:
1. Connect the Pan/Tilt port of the AXIS 240 to the Pan/Tilt port
of the camera using an RS232 cable.