User Manual
Table Of Contents
- Cover
- Section 1 Introduction
- Section 2 Installing the AXIS 240
- Section 3 Assigning an IP Address
- Section 4 Configuring the AXIS 240
- Section 5 Using the AXIS 240
- Appendix A Troubleshooting
- Appendix B The Parameter List
- Appendix C Updating the Software
- Appendix D Technical Specifications
- Appendix E The Auxiliary IO Port
- Appendix F The RS232 Serial Ports
- Appendix G Camera Applications
- Appendix H CRON Script Command Reference
Appendix F: The RS232 Serial Ports AXIS 240 Users Manual
102
Ernitec
It is possible to connect up to five Ernitec units to the AXIS 240,
if connected via an RS485 adapter. For each camera that you
intend to use, enable Pan/Tilt and specify an address 1-255. Click
Store device settings.
1. Click Port. If required, adjust the parameters for Baud rate, Data
bit, Stop bit and Parity for the Pan/Tilt port. Click Store port
settings.
2. Click Pan/Tilt control page to verify that the Pan/Tilt
installation is working properly.
Pelco Digital
Coaxitron
It is possible to connect up to five Pelco Digital Coaxitron units to
the AXIS 240, if connected via an RS485 adapter. For each
camera that you intend to use, enable Pan/Tilt and specify an
address 1-255. Click Store device settings.
1. Click Port. If required, adjust the parameters for Baud rate, Data
bit, Stop bit and Parity for the Pan/Tilt port. Click Store port
settings.
2. Click Pan/Tilt control page to verify that the Pan/Tilt
installation is working properly.
HTTP Protocol
The AXIS 240 supports input/output operations on the Pan/Tilt port
via the HTTP protocol. The functionality can be used for adjusting
the camera position or for controlling a simple device, such as a relay
switch.