User`s manual

SBC86831 Series All-In-One Mini ITX Board User’s Manual
Jumpers and Connectors
24
2.4.13 Parallel IDE Connector: CN18
An IDE device connects to the computer via an IDE connector. One
IDE connector can connect to one IDE cable, and the single IDE cable
can then connect to two IDE devices. If you wish to connect two IDE
devices, please set the jumper on one IDE device as Master and the
other as Slave.
1
2
39
40
Pin Signal Pin Signal Pin Signal
1 Reset # 2 GND 3 Data 7
4 Data 8 5 Data 6 6 Data 9
7 Data 5 8 Data 10 9 Data 4
10 Data 11 11 Data 3 12 Data 12
13 Data 2 14 Data 13 15 Data 1
16 Data 14 17 Data 0 18 Data 15
19 GND 20 No connector 21 No connector
22 GND 23 IOW # 24 GND
25 IOR # 26 GND 27 IOCHRDY
28 No connector 29 No connector 30 GND-Default
31 Interrupt 32 No connector 33 SA1
34 No connector 35 SA0 36 SA2
37 HDC CS0 # 38 HDC CSI # 39 HDD Active #
40 GND