User`s manual

SBC86822 Series All-In-One Mini ITX Board User’s Manual
Jumpers and Connectors
30
2.4.5 USB1/USB2 Connectors (CN8, CN11)
These Universal Serial Bus (USB) connectors on this board are for
installing versatile USB interface peripherals. These are 10-pin
standard USB connectors.
Pin Signal Pin Signal
1 +5V 2 +5V
3 USB D0- 4 USB D1-
5 USB D0+ 6 USB D1+
7 Ground (GND) 8 Ground (GND)
9 Ground (GND) 10 Ground (GND)
CN8
Pin Signal Pin Signal
1 +5V 2 +5V
3 USB D2- 4 USB D3-
5 USB D2+ 6 USB D3+
7 Ground (GND) 8 Ground (GND)
9 Ground (GND) 10 Ground (GND)
CN11
2.4.6 Ethernet with USB Connectors (LAN1, LAN2)
The SBC86822 Series has three layers of GIGA Ethernet & USB
Connectors (CN9, CN12).
The RJ-45 connector is for Ethernet. To connect the board to a 100/10
Base-T hub, just plug one end of the cable into CN9A and CN12A, and
connect the other end (phone jack) to a 1000/100/10-Base-T hub.
The lower double-deck USB Connector (CN9B, CN12B) supports USB
2.0 compliant (480Mbps) that can be connected to any USB
peripherals, such as keyboard, mouse, scanner.
Please refer to the pin assignment list next page.