User`s manual

OPS860-HM User’s Manual
Introduction
11
 Location of JAE TX25 Plug Connector
Please refer to the following drawing for location of the JAE
TX25 plug connector. Pin 1 of the connector is located at
114.8 mm from the edge of the module, and 106.9 mm from
the inner side of the front panel. For mating tolerance of TX25
plug connector and TX24 receptacle connector, please refer
to the JAE specification
 Vent Holes at the Pluggable Module Back Panel
On the OPS860-HM Module, it is recommended by Intel that
some vent holes be opened at the back so that hot air can
escape more easily from the module that the FAR in on both
sides of the module back panel should be greater than 0.25.