User`s manual

NANO830/831 Intel

Atom

D2550/N2600 Processor Nano-ITX Board

20 Board and Pin Assignments

LAN

USB

2.4.12 Ethernet and USB Port Stacks (CN12 and CN13)

The board has two RJ-45 connectors. Ethernet connection can be established by

plugging one end of the ethernet cable into this RJ-45 connector and the other end

(phone jack) to a 1000/100/10-Base-T hub.

The lower Universal Serial Bus (compliant with USB 2.0 (480Mbps)) connector on the

rea

r I/O are for installing USB peripherals such as keyboard, mouse, scanner, etc.

Note that the CN12 carries ethernet port

1, USB port 0 and USB port 1, while the CN13

carries ethernet port 2, USB port 2 and USB port 3.

2.4.13 VGA Connector (CN14)

The CN14 is a high rise 15-pin D-Sub connector which is commonly used for CRT VGA

monitor. This VGA interface configuration can be configured via software utility.

Pin LAN Signal Pin LAN Signal

L1 MDI0+ L5 MDI2-

L2 MDI0- L6 MDI1-

L3 MDI1+ L7 MDI3+

L4 MDI2+ L8 MDI3-

A 100 LAN LED (Green) / 1000 LAN LED (Orange)

B Active LED (Yellow)

Pin USB Port 0 Pin USB Port 1

1 USB VCC (+5V level) 5 USB VCC (+5V level)

2 USB #0_D- 6 USB #1_D-

3 USB #0_D+ 7 USB #1_D+

4 GND 8 GND

Pin USB Port 2 Pin USB Port 3

1 USB VCC (+5V level) 5 USB VCC (+5V level)

2 USB #2_D- 6 USB #3_D-

3 USB #2_D+ 7 USB #3_D+

4 GND 8 GND

Pin Signal Pin Signal

1 Red 2 Green

3 Blue 4 N.C.

5 GND 6 DETECT

7 GND 8 GND

9 VCC 10 GND

11 N.C. 12 DDC DATA

13 Horizontal Sync 14 Vertical Sync

15 DDC CLK