User`s manual

NA-821 Series Network Appliance User’s Manual
Phoenix-Award BIOS Utility
47
saved to main memory that remains powered while most other
hardware components turn off to save energy. The information
stored in memory will be used to restore the system when a “wake
up” event occurs.


 Run VGABIOS if S3 Resume
When this item is set Auto, the system will run VGA BIOS if it is
resumed from the S3 state.


 Power Management
This option allows you to select the type (or degree) of power
saving for Doze, Standby, and Suspend modes. The table below
describes each power management mode:
Max Saving
It is maximum power savings, only available for SL CPUs. The
inactivity period is 1 minute in each mode.
User Define
It sets each mode. Select time-out periods in the PM Timers
section.
Min Saving
It is minimum power savings. The inactivity period is 1 hour in
each mode (except the hard drive).
Disabled
Default value


 Video Off Method
This setting determines the manner in which the monitor is blanked.
V/H SYNC+Blank
Turns OFF vertical and horizontal
synchronization ports and writes blanks to the
video buffer
DPMS
Select this option if your monitor supports the
Display Power Management Signaling (DPMS)
standard of the Video Electronics Standards
Association (VESA). Use the software supplied
for your video subsystem to select video power
management values.
Blank Screen
System only writes blanks to the video buffer.


 Video Off In Suspend
This item defines if the video is powered down when the system is
put into suspend mode.


 Suspend Type
If this item is set to the default Stop Grant, the CPU will go into Idle
Mode during power saving mode.