User`s manual

MANO873 Series All-In-One Mini ITX Board
Hardware Installation 27
3.2 Installing the Memory
The board supports two 204-pin DDR3 SO-DIMM memory sockets with maximum memory
capacity up to 16GB.
Note: A DDR3 module has the same physical dimensions as a DDR2 SO-DIMM but is
notched differently to prevent installation on a DDR2 SO-DIMM socket.
Please follow steps below to install the memory modules:
 Push down latches on each side of the SO-DIMM socket.
 Align the memory module with the socket that notches of memory module must match the
socket keys for a correct installation.
 Install the memory module into the socket and push it firmly down until it is fully seated.
The socket latches are levered upwards and clipped on to the edges of the SO-DIMM.
 Install any remaining SO-DIMM modules.