User`s manual

MANO831 Mini ITX Board
28 Hardware Installation
3.4.2 Configuring an Expansion Card
After installing the expansion card, configure it by adjusting the software settings.
1. Turn on the system and change the necessary BIOS settings, if any. See Chapter 5
for information on BIOS setup.
2. Assign an IRQ to the card if needed.
3. Install the software drivers for the expansion card.
3.4.3 PCI Slot
This motherboard supports one PCI slot that complies with the PCI specifications. The
following figure shows an IC card installed on the PCI slot.
3.4.4 PCI-Express Mini Card Connector
This motherboard supports one PCI-Express Mini Card connector that complies with the
PCI-Express Mini Card specifications. The following figure shows a capture card
installed on this connector.