User`s manual

MANO120 Mini-ITX SBC User’s Manual
Introduction
18
1.8.3 ATX Power Connector (ATXPWR)
These connectors are for ATX power supply plugs. The power supply plugs are designed to fit
these connectors in only one orientation. Find the proper orientation and push down firmly
until the connectors completely fit.
EATXPWR
Important notes on the Motherboard Power Requirements
 Make sure that your ATX 12V power supply can provide 8A on the
+12V lead and at least 1A on the +5-volt standby lead (+5VSB). The
minimum recommended wattage is 230W, or 300W for a fully
configured system. The system can become unstable and might
experience difficulty powering up if the power supply is inadequate.
 You must install a PSU with a higher power rating if you intend to
install additional devices.