User`s manual

EP850 All-In-One EPIC Board User’s Manual

Jumpers and Connectors

2.4.12 VGA Connector (CN14)

CN14 is a standard 15-pin pin DB15 connector commonly used for the

CRT VGA display.

Pin Signal Pin Signal Pin Signal

1 Red 2 Green 3 Blue

4 N/A 5 GND 6 AGND

7 AGND 8 AGND 9 N/A

10 GND 11 N/A 12 DDC DAT

13 Horizontal Sync 14 Vertical Sync 15 DDC CLK

2.4.13 Ethernet Connectors (LAN1, LAN2)

The RJ-45 connector is for Ethernet. To connect the board to 100-

Base-T or 1000-Base-T hub, just plug one end of the cable into the

LAN1 or LAN2, and connect the other end (phone jack) to a 100-Base-

T hub or 1000-Base-T

hub.

Pin Signal

1 Tx+ (Data transmission positive)

2 Tx- (Data transmission negative)

3 Rx+(Data reception positive)

4 RJ-1(For 100 base T-Only)

5 RJ-1(For 100 base T-Only)

6 Rx- (Data reception negative)

7 RJ-1(For 100 base T-Only)

8 RJ-1(For 100 base T-Only)

A Active LED

B 100/1000 LAN LED